Operating Instructions and Parts Manual 3-Roll Powered Stock Feeder Model PF3-JR WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVe
106. Place the base over the hole pattern. Align the four holes of the base with the holes in the mounting surface. Make sure the lock handle is pos
11Grounding Instructions Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be
12The green colored rigid ear, lug, or tab, extending from the adapter, must be connected to a permanent ground such as a properly grounded outlet bo
133. Loosen lock handle (B, Figure 10) and rotate the swivel cone (C, Figure 10) 180-degrees, as shown in Figure 10. 4. Re-tighten lock handle (B, F
14Operating Controls The control switch (Figure 14) turns the motor on, and also determines its direction – forward or reverse. If a jam should oc
156. When used in normal horizontal position, the stock feeder should be adjusted for height so that the distance between the table and the feed rol
16When Used with a Table Saw 1. Position the Stock Feeder so that the axis of the saw blade lines up between the center roller and infeed roller. Se
17The mating parts of the arm cone and swivel cone should be kept clean. See Figure 21. When disassembling any of the cones from the stock feeder, wi
18Chains Lubricate the drive chains (Figure 24) with good quality all-purpose grease every 3 months, or more frequently if needed. Lead Scr
19Troubleshooting Trouble Probable Cause Remedy Feeder will not start. Not connected to power source. Check plug connection. Fuse blown, or circuit
2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au
20Parts List: PF3-JR Stand Assembly Index No. Part No. Description Size Qty 1 ... PF3JR-101 ...Base ...
21Exploded View: PF3-JR Stand Assembly
22Parts List: PF3-JR Stock Feeder Index No. Part No. Description Size Qty 1 ... PF3JR-201 ...Oil Cap ...
23Exploded View: PF3-JR Stock Feeder
24Electrical Connections for PF3-JR Stock Feeder
25Boring Template SCALE 1:1 Cut out and tape into place on mounting surface.
26NOTES
27
28 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.powermati
3 Table of Contents Warranty and Service...
4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t
5 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention. Looking ar
6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a Model PF3-J
7 Features
8 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca
9 Assembly and Installation Tools needed for assembly: 5mm hex wrench 12mm and 14mm open end wrenches Remove the clear plastic from around the feede
Commentaires sur ces manuels