Operating Instructions and Parts Manual 16-inch Open-End Belt Sander Model 1632 WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60123 Par
10OPERATION CONTROLS (Figure 7): Emergency stop (A) will stop the feeding belt and sanding belt. The button must be turned clockwise to reset sand
11 6. Turn on the power to the machine. 7. Start the sanding belt. 8. Start the feeding conveyor. NOTE: If you are sanding a workpiece greater
TROUBLE-SHOOTING for 1632 Open-End Sander PROBLEM POSSIBLE CAUSE SOLUTION The sanding belt clogs 1. Sandpaper grit too small. 1. Use larger gr
13PARTS LIST: Air Control Assembly (1632 Sander) No. Part No. Description Quantity 1 6293482 Filter ...
14PARTS LIST: Electricity Control & Upper Adj. Roller (1632 Sander) No. Part No. Description Quantity 1 6293203 Upper Door (L) ...
15Electricity Control & Upper Adj. Roller (1632 Sander)
16PARTS LIST: Sanding Drum Assembly (1632 Sander) No. Part No. Description Quantity 1 6293240 Ring ...
17PARTS LIST: Sanding Drum Assembly (1632 Sander) continued No. Part No. Description Quantity 54 6293294 Pad...
18Sanding Drum Assembly (1632 Sander)
19PARTS LIST: Base & Table Adjust Assembly (1632 Sander) No. Part No. Description Quantity 1 6293240 Ring...
2 This manual has been prepared for the owner and operators of a Powermatic Model 1632 Sander. Its purpose, aside from machine operation, is to promo
20PARTS LIST: Base & Table Adjust Assembly (1632 Sander) continued No. Part No. Description Quantity 53 6293218 Flat Washer, 3/8...
21Base & Table Adjust Assembly (1632 Sander)
22PARTS LIST: Conveyor Belt & Table; Reduction Motor (1632 Sander) No. Part No. Description Quantity 1 6293351 Hex Socket Cap Screw,
23PARTS LIST: Conveyor Belt & Table; Reduction Motor (1632 Sander) continued No. Part No. Description Quantity 55 6293289 Hex Nut, 5
24Conveyor Belt & Table (1632 Sander)
25Reduction Motor (1632 Sander)
26ELECTRICAL SCHEMATIC (1632 Sander) 460V – 3 Phase
27ELECTRICAL SCHEMATIC (1632 Sander) 230V – 1 Phase / 3 Phase
28 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com
3TABLE OF CONTENTS Safety Rules...
4 SAFETY RULES As with all machines, there is a certain amount of hazard involved with the use of this sander. Use the machine with the respect and
5Careless acts. Give the work you are doing your undivided attention. Looking around, carrying on a conversation, and “horseplay” are careless acts t
SPECIFICATIONS: 1632 Open-End Sander Working width (reversing stock) ...
7RECEIVING THE SANDER Remove the sander from its crate and inspect for damage to ensure all parts are intact. Any damage should be reported to your
86. Turn on the feed belt and verify that the belt feeds into the machine. It if turns toward the user, disconnect the machine from the power sourc
9 NOTE: There is a limit switch at both ends of the upper roller. If the sanding belt comes in contact with these limit switches, the brakes will b
Commentaires sur ces manuels