BELT & DISC SANDER Model 31A Instruction Manual & Parts List M-0460267 (800) 274-6848 www.powermati
10 3. Make final adjustments to the tracking by momentarily starting and stopping the motor while at the same time adjusting the tracking screw (F)
11positions of the arm). Use a 10mm hex wrench to remove or install the work stop. BELT ARM POSITIONING Your sander is equipped with a shot pin ar
12 FENCE/TABLE The fence attachment is used with the belt sander and can be positioned alternately as a table (with the belt arm in upright posit
13TYPES OF OPERATIONS Flat surface sanding is demonstrated in Figure 16, where the major surface is sanded in a flat plane. Edge sanding is a com
14GRIT COMPARISON CHART Accessories SANDING BELTS 57617110 6” x 48” Sanding Belt, 24 Grit, Closed Coat* 57617210 6” x 48” Sanding Belt, 40 Grit
15TROUBLE SHOOTING for Model 31A Sander Problem Cause Solution Machine fails to start. 1. Faulty switch. 1. Replace switch. 2. Bad motor. 2.
16PARTS LIST: Body Assembly (Model 31A Sander) No. Part No. Description Quantity 1 31A-1 Cast Base ...
17 No. Part No. Description Quantity 57 31A-51 Set
18Body Assembly (Model 31A Sander)
19PARTS LIST: Stand Assembly (Model 31A Sander) No. Part No. Description Quantity 1 31A-78 Stand...
2 This manual has been prepared for the owner and operators of a Powermatic Model 31A Belt & Disc Sander. Its purpose, aside from machine operat
20 Stand Assembly (Model 31A Sander)
21 ELECTRICAL SCHEMATIC (Model 31A Sander)
22 ELECTRICAL SCHEMATIC (Model 31A Sander)
23 ELECTRICAL SCHEMATIC (Model 31A Sander)
24 ELECTRICAL SCHEMATIC (Model 31A Sander)
25
26
27To order parts or reach our service department, please call our toll-free number between 8:00 a.m. and 4:30 p.m. (CST), Monday through Friday. Hav
2807/02 WMH Tool Group P.O. Box 1349 Auburn, WA 98071-1349 Phone:(800) 274-6848 Fax: (800) 274-6840 E-mail: powermatic@wmh
3TABLE OF CONTENTS Safety Rules ...
4! SAFETY RULES As with all machines, there is a certain amount of hazard involved with the use of this sander. Use the machine with the respect an
5 Machine adjustments. Make all machine adjustments with power off except belt tracking. Belt tracking should be checked manually before starting t
6 ! SAFETY: Decal for Model 31A Sander Familiarize yourself with the location and content of this decal on your machine. 31A-102
7 SPECIFICATIONS: Model 31A Sander FIGURE 1 Disc size ...
8 RECEIVING Remove the sander and base and any loose parts from their containers. Check for damage and ensure all parts are intact. Any damage sho
9 WARNING: Electrical wiring should be done by a qualified electrician. The machine must be properly grounded to help avoid electrical shock
Commentaires sur ces manuels